Barn roof repair in Alvord, TX usually comes down to a handful of problems: screws that have backed out, rust spreading from laps and edges, panels lifted by wind off the open country, and hail-cracked skylight panels. Fixing them early keeps hay, tack and equipment dry and stops small leaks from rotting purlins.
If water is already getting into your barn, call Cannon Roofing at (940) 627-1045. We answer around the clock. You can also send photos and details through our contact page.
Common barn roof problems around Alvord
Alvord sits along US 81/287 in north Wise County, where barns face long fetches of wind with nothing to slow it down. Most barns here are covered in ribbed or corrugated steel over wood or steel purlins, and they age in predictable ways.
Backed-out screws and worn washers
Every exposed screw has a rubber washer that seals the hole. Years of sun and the panel expanding and contracting through hot days and cold nights loosen those screws and crack the washers. Water then follows the screw shank in. You often see drip stains on the purlins below before you notice anything from outside.
Rust at laps, edges and around fasteners
Older galvanized barn roofs rust first where water lingers: panel side laps, the bottom edge at the eave and around screws. Surface rust can sometimes be managed; rust that has eaten through the panel means that section needs replacing.
Wind-lifted panels and trim
Open-sided barns and loafing sheds catch wind underneath as well as over the top. That uplift works fasteners loose along the eave and gable ends first, and a single flapping panel can tear neighboring panels if it is left.
Hail-cracked skylight panels
The translucent panels many barns use for daylight get brittle in the sun, and hail can crack or punch through them. After a hailstorm they are often the first place a barn starts to leak.
What a proper barn roof repair in Alvord, TX involves
A good repair fixes the cause, not just the drip you can see. Here is how we approach it:
- Inspection from inside and out. We look up at the purlins for stains and rot, then check fasteners, laps, trim and ridge from the roof where it is safe to do so.
- Fastener work. Loose or stripped screws are replaced with new fasteners and washers, sized so they bite into sound wood or steel.
- Panel replacement. Rusted-through, torn or creased panels are swapped out with matching profile panels so laps line up and seal.
- Trim and ridge. Eave trim, rake trim and ridge cap are re-secured or replaced so wind has less to grab.
- Skylight panels. Cracked translucent panels are replaced with ones that fit the same rib profile.
When repair stops making sense
If rust is widespread, purlins are rotting in several bays, or the roof has been patched so many times that new leaks keep showing up, it is time to talk about re-roofing the barn. We will tell you honestly which side of that line your barn is on.
For more background on outbuildings, our guide to barn and shop roofing in Wise County covers materials and layout, and metal building roof repair goes deeper on fastener and panel issues.
Before the crew arrives
A little preparation makes a barn repair faster and safer for everyone. Move tractors, trailers and vehicles out from under the work area if you can, since screws and offcuts occasionally drop through. Let us know where livestock will be and whether any gates need to stay closed. If you have noticed drips in specific bays, mark them or snap a photo during the next rain; that helps us trace leaks that travel along purlins before they fall. Finally, tell us about any past patches, sealant jobs or replacement panels so we know what we are looking at up top.
Why barn repairs should not be a DIY weekend job
Corrugated and ribbed panels are slick, especially with morning dew, and many barns have little or no decking under the steel. Stepping between purlins can mean falling straight through. Older skylight panels look solid and are not. A crew with the right equipment and fall protection can do the work far more safely.
Working with Cannon Roofing on your Alvord barn
Cannon Roofing has been based in Decatur since 1994, a short drive south of Alvord. Our crew members hold the Technician Seal of Safety, which means they are background checked, drug tested, factory trained and insured, and that matters when people are working above your livestock and equipment.
Our roof repair service covers barns, shops and homes, and if a storm caused the damage, our insurance claims help includes documenting the condition of the roof for your adjuster. Farm and ranch policies differ, so it is worth checking how your barn is covered.
Barn size, panel condition and access all change the scope of a repair, so we do not publish prices. We start with a free inspection and give you a clear written estimate.
Frequently asked questions
Can you repair just part of a barn roof?
Yes. Most barn roof repairs are spot repairs: a run of loose screws, a few rusted panels, the ridge or a skylight panel. We match the panel profile so new pieces lap correctly with the old.
How soon should I fix a leaking barn roof?
As soon as you can. Water that drips on wood purlins and stored hay leads to rot and mold, and loose panels tend to get worse with every windy day.
Do you repair barn roofs after hail storms?
Yes. We inspect for punctured skylight panels, dents, cracked trim and loose fasteners, and we can document what we find if you decide to file a claim.
Ready to get your barn dry again? Call Cannon Roofing at (940) 627-1045, open 24/7, to schedule a free inspection of your Alvord barn. You can also reach us through our contact form, and we will follow up to set a time.